No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Improving the Stability of an OSPF Network

Improving the Stability of an OSPF Network

Applicable Environment

To reduce device load and improve network performance, configure OSPF timers to reduce the number of unnecessary packets on the network.

Pre-configuration Tasks

Before improving the stability of an OSPF network, complete the following task:

Configure basic OSPF functions.

Configuration Procedure

Perform one or more of the following configuration tasks as required (the task of Verifying the OSPF Network Security Optimization Configuration must be performed).

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 216731

Downloads: 194

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next