No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



IP fast reroute (FRR) is a method that implements fast route backup. It enables a router to immediately use a backup link for packet forwarding if the router detects a fault at the physical or data link layer. With IP FRR, the router also reports the fault to the upper-layer routing system.


On traditional IP networks, when a fault occurs at the lower layer of the forwarding link, the physical interface on the router becomes Down. After the router detects the fault, it informs the upper-layer routing system to recalculate routes and then update routing information. Usually, it takes the routing system several seconds to re-select an available route.

Second-level convergence is intolerable to services that are sensitive to delay and packet loss because it may lead to service interruption. For example, Voice over Internet Protocol (VoIP) services are only tolerant of millisecond-level interruption.

IP FRR resolves this by ensuring that the forwarding system rapidly detects a link fault and then uses a backup route to restore services as soon as possible.

IP FRR Classification and Implementation

IP FRR, which is designed for routes on IP networks, is classified into IP FRR on public networks and IP FRR on private networks.

  • IP FRR on public networks protects routers on public networks.

  • IP FRR on private networks protects Customer Edges (CEs).

IP FRR is implemented as follows:

  1. If the primary link is available, you can configure an IP FRR policy to provide the forwarding information of the backup route to the forwarding engine.

  2. If the forwarding engine detects a primary link fault, the engine uses the backup link to forward traffic before the routes on the control plane converge.

IP FRR Typical Application

In the example shown in Figure 1-3, IP FRR is configured to improve network reliability. CE1 is dual-homed to PE1 and PE2 and has two outbound interfaces and two next hops configured. That is, link B functions as the backup of link A. When link A fails, traffic can be rapidly switched to link B.

Figure 1-3  IP FRR
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 274791

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next