No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an RD Filter

Configuring an RD Filter


You can use an RD filter when using the RD attribute to filter routes in a VPN.


  1. Run system-view

    The system view is displayed.

  2. Run ip rd-filter rd-filter-number { deny | permit } route-distinguisher &<1-10>

    An RD filter is configured.

Verifying the Configuration

  • Run the display ip rd-filter [ rd-filter-number ] command to check information about a configured RD filter.

Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 224805

Downloads: 195

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next