No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD for IPv6 Static Routes

Configuring Static BFD for IPv6 Static Routes

Usage Scenario

To use BFD sessions to provide link detection for IPv6 static routes, you can bind IPv6 static routes to BFD sessions. One IPv6 static route can be bound to one BFD session.

Optimal IPv6 static routes are delivered to the forwarding table for packet forwarding. However, IPv6 static routes cannot detect the status of the link to the next hop. You can bind IPv6 static routes to BFD sessions. A BFD session can fast detect changes over a link and inform the routing management system of the changes. The routing management system immediately deletes the static route that is bound to the BFD session from the forwarding table and recalculates another active route. In this manner, fast route convergence is implemented.

Pre-configuration Tasks

Before configuring static BFD for IPv6 static routes, complete the following tasks:

  • Configure link layer protocol parameters and IP addresses for interfaces and ensure that the link layer protocol of the interfaces is Up.

  • Configure a BFD session. For details, see BFD Configuration in the S7700 and S9700 V200R011C10 Configuration Guide - Reliability.

    .

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6 route-static dest-ipv6-address prefix-length { interface-type interface-number [ nexthop-ipv6-address ] | nexthop-ipv6-address | vpn-instance vpn-destination-name nexthop-ipv6-address } [ preference preference | tag tag ] * [ track bfd-session cfg-name ] [ description text ]

    A BFD session is bound to an IPv6 static route.

    NOTE:

    Before associating a static route with a BFD session, ensure that the BFD session and static route are on the same link.

    When a BFD session is associated with VRRP or a static route, the system does not allow the associated BFD session to be deleted by default. To delete the associated BFD session, run the bfd session nonexistent-config-check disable command to prevent the device from checking whether the associated BFD session is deleted. However, deleting the BFD session will prevent the configured association function from being implemented.

Verifying the Configuration

Run the following commands to check the previous configuration.

Information about a BFD session can be viewed only after parameters of the BFD session are set and the BFD session is established.

  • Run the display bfd session { all | discriminator discr-value } [ verbose ] command to check information about BFD sessions.

  • Run the display current-configuration | include bfd command to check configurations of BFD for IPv6 static routes.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 215067

Downloads: 194

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next