No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Controlling the Valid Time of Routing Policies

Controlling the Valid Time of Routing Policies

Pre-configuration Tasks



  1. Run system-view

    The system view is displayed.

  2. Run route-policy-change notify-delay delay-time

    The delay in applying the routing policy is set.

    The value ranges from 1 to 180, in seconds.

    By default, the RM immediately instructs protocols to apply a new policy when the existing routing policy changes.

  3. Run quit

    Return to the user view.

  4. (Optional) Run refresh bgp all { export | import }

    BGP is configured to apply the new routing policy.

    After a routing policy is configured, to make policy-based filtering take effect immediately, use this command to configure BGP to apply the new policy immediately.

    The policies affected by the timer are ACLs, IP prefix lists, AS_Path filters, community filters, extended community filters, RD filters, and route-policies.

Verifying the Configuration

  • Run the display current-configuration | include notify-delay command to check the delay in applying a routing policy.

Updated: 2020-02-04

Document ID: EDOC1000178324

Views: 286167

Downloads: 229

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next