No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPFv3 IPSec Configuration

Verifying the OSPFv3 IPSec Configuration

Procedure

  • Run the display ipsec proposal [ name proposal-name ] command to check IPSec proposal information.
  • Run the display ipsec sa [ name sa-name ] [ brief ] command to check information about a Security Association (SA).
  • Run the display ipsec statistics [ sa-name sa-name slot slot-number ] command to check statistics about packets processed by IPSec.
  • Run the display ospfv3 [ process-id ] command to check the SA applied in a specified process.
  • Run the display ospfv3 [ process-id ] interface command to check the SA applied on a specified interface.
  • Run the display ospfv3 [ process-id ] area [ area-id ] command to check the SA applied in a specified area.
  • Run the display ospfv3 [ process-id ] vlink command to check the SA applied on the peer end of a virtual link.
  • Run the display ospfv3 [ process-id ] sham-link command to check the SA applied on the peer end of a sham link.
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 235628

Downloads: 205

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next