No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for OSPF

Default Settings for OSPF

Table 5-17 describes the default settings for OSPF.

Table 5-17  Default settings for OSPF
Parameter Default Setting
OSPF Disabled
Interval at which Hello packets are sent 10 seconds on P2P and broadcast interfaces; 30 seconds on P2MP and NBMA interfaces
Dead interval after which OSPF neighbor relationships expire 40 seconds on P2P and broadcast interfaces; 120 seconds on P2MP and NBMA interfaces
Period during which a device acts as a stub router 500 seconds
Bandwidth reference value used to calculate a link cost 100 Mbit/s
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 276373

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next