No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Prohibiting an OSPF Interface from Sending and Receiving Protocol Packets

Prohibiting an OSPF Interface from Sending and Receiving Protocol Packets


To prevent devices on other networks from obtaining local OSPF routing information, and to prevent the local device from receiving the routing update information advertised by other devices on the same network, prohibit an OSPF interface from sending and receiving protocol packets. Such a configured interface can continue to advertise its direct routes; however, it no longer sends Hello packets. This ensures that no neighbor relationship can be set up through the interface, which enhances OSPF networking capabilities and reduces network resource consumption.


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF view is displayed.

  3. Run silent-interface { all | interface-type interface-number }

    An OSPF interface is prohibited from sending and receiving protocol packets.

    By default, an interface is allowed to send and receive protocol packets.

    You can prohibit an interface from sending and receiving OSPF packets in different OSPF processes, but the silent-interface command is valid only for the OSPF interface in the local process.

Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 273429

Downloads: 222

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next