No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Interval at Which Hello Packets are Sent

Configuring an Interval at Which Hello Packets are Sent

Context

Hello packets are sent periodically to the neighbor switch to establish and maintain a neighbor relationship and to elect a designated router (DR) and a backup DR (BDR). RFC 2328 requires that the Hello timer values of neighbors be consistent. The value of the Hello timer is inversely proportional to the route convergence speed and network load.

Perform the following operations on the switch that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run ospfv3 timer hello interval [ conservative ] [ instance instance-id ]

    The interval at which Hello packets are sent is set on the interface.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 234546

Downloads: 205

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next