No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for URPF

Application Scenarios for URPF

URPF Strict Check

AS1 and AS2, respectively, establish a single connection with AS3.

As shown in Figure 14-2, AS1 and AS2 establish a single connection with AS3, respectively. URPF is enabled on Interface1 and Interface2 of SwitchC to protect AS3 from source address spoofing attacks from AS1 and AS2.

Assumes that PC A in AS1 generates a packet with the bogus source IP address 10.2.2.2 and sends the packet to the server in AS3. After receiving the packet, SwitchC checks the inbound interface of the packet and finds that the packet with the destination IP address 10.2.2.2 must reach SwitchC through Interface2. SwitchC considers the packet as a bogus packet and discards it.

The packet sent from AS2 to the server is forwarded after passing URPF check.

Figure 14-2  URPF strict check application

URPF Loose Check

URPF is used when multiple connections are set up between two network edge devices.

  • Single-ISP scenario

    Figure 14-3  URPF enabled in the single-ISP scenario

    As shown in Figure 14-3, two connections are set up between the enterprise and ISP devices to ensure reliability. In this case, route symmetry between the enterprise and ISP devices cannot be ensured. Therefore, URPF loose check is used.

  • Multi-ISP scenario

    Figure 14-4  URPF enabled in the multi-ISP scenario

    As shown in Figure 14-4, the enterprise is connected to several ISPs. Route symmetry between the enterprise and the two ISP devices cannot be ensured. Therefore, URPF loose check is used.

    URPF enabled on multi-homed client connected to several ISPs can be applied to the following situations:

    • If specified packets are required to pass the URPF check in any situations, you can create an ACL to permit packets with specified source IP addresses to pass through.

    • The devices connected to users may only have a default route to the ISP. Therefore, matching the default routing entry needs to be supported.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 126196

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next