No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Optimized ARP Reply

Optimized ARP Reply

In Figure 7-2, the gateway receives a large number of ARP Request packets to request its interface MAC address. If all these ARP Request packets are sent to the CPU, the CPU usage of the MPU increases, and other services are affected.

Figure 7-2  Networking of optimized ARP reply
To address the preceding problem, enable optimized ARP reply, which improves the switch's capability of defending against ARP flood attack. After this function is enabled, the switch performs the following operations:
  • When receiving an ARP Request packet of which the destination IP address is the local interface address, the LPU directly returns an ARP Reply packet.
  • When a switch receives an ARP Request packet of which the destination IP address is not the local interface address and intra-VLAN proxy ARP is enabled on the switch, the LPU checks whether the ARP Request packet meets the proxy condition. If so, the LPU returns an ARP Reply packet. If not, the LPU discards the packet.
The optimized ARP reply function is applicable to the device with multiple LPUs configured.
By default, the optimized ARP reply function is enabled. After a device receives an ARP Request packet, the device checks whether an ARP entry corresponding to the source IP address of the ARP Request packet exists.
  • If the corresponding ARP entry exists, the switch performs optimized ARP reply to this ARP Request packet.
  • If the corresponding ARP entry does not exist, the switch does not perform optimized ARP reply to this ARP Request packet.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 125403

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next