No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time for Port Attack Defense

Setting the Aging Time for Port Attack Defense

Context

After a device with port attack defense function enabled detects an attack on a port, the device traces the source and limits the rate of the attack packets on the port within the aging time (T seconds). When the aging time expires, the device calculates the protocol packet rate on the port again. If the rate is still above the protocol rate threshold, the device keeps tracing the source and limits the rate of the attack packets; otherwise, the device stops tracing the source.

If the aging time is too short, the device frequently starts packet rate detection on ports, which consumes CPU resources. If the aging time is too long, protocol packets cannot be promptly processed by the CPU, which affects services. Therefore, balance between the service operation status and CPU usage when setting an aging time.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run cpu-defend policy policy-name

    The attack defense policy view is displayed.

  3. Run auto-port-defend aging-time time

    The aging time for port attack defense is set.

    By default, the aging time for port attack defense is 300 seconds.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 126322

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next