No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Traffic Suppression for ICMP Packets

Configuring Traffic Suppression for ICMP Packets

Context

Malicious users may flood a network with ICMP packets to initiate an attack. Processing large numbers of ICMP packets will consume many CPU resources and cause service abnormalities. To resolve this problem, configure ICMP packet suppression.

After ICMP packet suppression is configured on an interface, the system automatically discards ICMP packets when the number of ICMP packets sent by an interface to the CPU every second exceeds the rate threshold.

Before configuring ICMP packet suppression on an interface, run the undo icmp-reply fast command to disable the ICMP reply fast function.

Pre-configuration Tasks

Before configuring traffic suppression for ICMP packets, configure link layer protocol parameters for interfaces to ensure that the link layer protocol status on the interfaces is Up.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run icmp rate-limit enable

    Traffic suppression for ICMP packets is enabled.

    By default, traffic suppression for ICMP packets is disabled.

  3. Run icmp rate-limit { total | interface interface-type interface-number [ to interface-number ] } threshold threshold-value

    The rate threshold for ICMP packets in the interface and system views is configured.

    By default, the global rate limit of ICMP packets is 256 pps and the rate limit of ICMP packets on an interface is 192 pps.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 126308

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next