No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Attack Source Punish Actions

Configuring Attack Source Punish Actions

Context

A device with the punish actions configured identifies the attack source and performs punish actions on the attack source to protect the device. The punish actions include:
  • Discard the packets from the attack source.
  • Change the status of the interface receiving attack packets to shutdown.

If the device changes the inbound interface status to shutdown, services of authorized users on the interface are also interrupted. Exercise caution when you configure the device to shut down the interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run cpu-defend policy policy-name

    The attack defense policy view is displayed.

  3. Run auto-defend enable

    Attack source tracing is enabled.

    By default, attack source tracing is enabled.

  4. Run auto-defend action { deny [ timer time-length ] | error-down }

    The punish function is enabled and a punish action is configured.

    By default, the punish function is disabled.

    NOTE:

    The device does not trace the source of users in the whitelist.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 126300

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next