No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the URPF Configuration

Verifying the URPF Configuration

Procedure

  • Run the display this command in the system view and interface view to check whether URPF is enabled.

  • Run the display traffic classifier user-defined [ classifier-name ] command to check the traffic classifier configuration.
  • Run the display traffic behavior user-defined [ behavior-name ] command to check the traffic behavior configuration.
  • Run the display traffic policy user-defined [ policy-name [ classifier classifier-name ] ] command to check the user-defined traffic policy configuration.

  • Run the display traffic-applied [ interface [ interface-type interface-number ] | vlan [ vlan-id ] ] { inbound | outbound } [ verbose ] command to check information about ACL-based simplified and MQC-based traffic policies applied to the system, a VLAN, or an interface.

    NOTE:

    Traffic policies can be applied to a sub-interface, but the display traffic-applied command cannot be used to check information about ACL-based simplified and MQC-based traffic policies applied to the sub-interface.

  • Run the display traffic policy { interface [ interface-type interface-number [.subinterface-number ] ] | vlan [ vlan-id ] | global } [ inbound | outbound ] command to check the traffic policy configuration.

  • Run the display traffic-policy applied-record [ policy-name ] command to check the application record of a specified traffic policy.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 126518

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next