No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring ARP Gateway Anti-Collision

Configuring ARP Gateway Anti-Collision

Context

If an attacker forges the gateway address to send ARP packets with the source IP address being the IP address of the gateway on the LAN, ARP entries on hosts in the LAN record the incorrect gateway address. As a result, all traffic from user hosts to the gateway is sent to the attacker and the attacker intercepts user information. Communication of users is interrupted.

To prevent bogus gateway attacks, enable ARP gateway anti-collision on the gateway. The gateway considers that a gateway collision occurs when a received ARP packet meets either of the following conditions:
  • The source IP address in the ARP packet is the same as the IP address of the VLANIF interface matching the physical inbound interface of the packet.
  • The source IP address in the ARP packet is the virtual IP address of the inbound interface but the source MAC address in the ARP packet is not the virtual MAC address of the VRRP group.
The device generates an ARP anti-collision entry and discards the received packets with the same source MAC address and VLAN ID in a specified period. This function prevents ARP packets with the bogus gateway address from being broadcast in a VLAN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run arp anti-attack gateway-duplicate enable

    ARP gateway anti-collision is enabled.

    By default, ARP gateway anti-collision is disabled.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 125726

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next