No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S9300, S9300E, and S9300X V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining IPSG

Maintaining IPSG

Table 12-9 lists the operations related to IPSG.

Table 12-9  Maintaining IPSG

Action

Command

Display static binding entries.

display dhcp static user-bind { { interface interface-type interface-number | ip-address ip-address | mac-address mac-address | vlan vlan-id } * | all } [ verbose ]

When the verbose parameter is specified, you can check whether IPSG takes effect for the binding entry.

Display information about the DHCP snooping dynamic binding table.

display dhcp snooping user-bind { { interface interface-type interface-number | ip-address ip-address | mac-address mac-address | vlan vlan-id }* | all } [ verbose ]

When the verbose parameter is specified, you can check whether IPSG takes effect for the binding entry.

Display information about the ND snooping dynamic binding table.

display nd snooping user-bind all [ verbose ] or display nd snooping user-bind { ipv6-address ipv6-address | mac-address mac-address | interface interface-type interface-number | vlan vlan-id }* [ verbose ]

When the verbose parameter is specified, you can check whether IPSG takes effect for the binding entry.

Display IP Source Trail statistics.

display ip source-trail [ ip-address ip-address [ slot slot-id | verbose ] ]

Clear IP Source Trail statistics.

NOTICE:

The cleared IP Source Trail statistics cannot be restored. Exercise caution when you run this command.

reset ip source-trail [ ip-address ip-address ]

  • When the ip-address ip-address parameter is specified, the IP Source Trail statistics of the specified destination IP address are cleared.
  • When the ip-address ip-address parameter is not specified, all IP Source Trail statistics are cleared.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178410

Views: 126764

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next