No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S9300, S9300E, and S9300X V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ethernet Submenu

Ethernet Submenu

Context

In the BootLoad menu, you can specify the system software after uploading it to the switch. The size of the system software is hundreds of bytes. Compared with using the serial port, transferring the system software over Ethernet submenu using FTP or TFTP provides much faster transfer speeds.

Before transferring files using the Ethernet submenu, deploy an FTP or TFTP server as the file server and connect the switch to the FTP or TFTP server using the Ethernet port (management interface).

Select 2 from the BootLoad menu to access the Ethernet submenu.
2
        Ethernet Submenu

     1. Download file to Flash through ethernet interface
     2. Upload Configuration file through ethernet interface
     3. Modify parameters
     4. Return

Enter your choice(1-4): 
Table 11-2  Ethernet submenu

Item

Description

1. Download file to Flash through ethernet interface

Downloads the system software to the flash memory based on information set in 3. Modify parameters.

The flash memory works on the switch and stores startup files including the system software and configuration file. Before upgrading the system software, download the system software to the flash memory.

2. Upload Configuration file through ethernet interface

Uploads the configuration file to the FTP or TFTP server for backup.

3. Modify parameters

Allows you to modify parameters on the Ethernet port. Before uploading files using the Ethernet port, properly set the IP addresses of the main control card and FTP or TFTP server, name of the system software, and user name and password of the FTP or TFTP server.

Enter the preset IP address, user name, and password of the server. Ensure that the MPU IP address can communicate with the FTP or TFTP server address. By default, the IP address of the management interface is 192.168.1.10:ffffff00. The following shows an example:
current board ip:
input new :192.168.1.2         //Configure an IP address for the management interface on the MPU.
current netmask:
input new : 255.255.255.0          //Configure an IP address subnet mask for the management interface on the MPU.
current server ip:
input new : 192.168.1.1        //Enter the server IP address.
current file name:
input new : S9300V200R011C10.CC         //Enter system software to be loaded.
current user name:
input new : huawei          //Enter the server user name.
current user password:
input new :                //Enter the server password.
current flag:0x0
input new :                //Select the transfer protocol type.

4. Return

Returns to the BootLoad menu.

Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178413

Views: 68232

Downloads: 109

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next