No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S9300, S9300E, and S9300X V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Manually Replacing Faulty Devices Using the Commander

Manually Replacing Faulty Devices Using the Commander

Context

When a client on a network supporting EasyDeploy fails, you can configure replacement information on the Commander so that the new client can quickly obtain the configuration file of the faulty one. This minimizes impact of client failures on the network.

This faulty device replacement function can only be implemented on a network that already has EasyDeploy configured.

In addition, automatic configuration file backup must be enabled on the Commander using the backup configuration interval interval [ duplicate ] command. If the new client fails to obtain backup configuration file information after you start the unconfigured device deployment process, it attempts to obtain configuration file information from the client database. If the new client still fails to obtain configuration file information, it uses default configuration file information. The default configuration of the new client may differ from the configuration of the faulty client.

Pre-configuration Tasks

Before manually replacing faulty devices using the Commander, complete the following tasks:
  • Configure a routing protocol to ensure that the DHCP server, file server, Commander, and new client (has obtained an IP address) have reachable routes to each other.
  • Configure a file server, configure the DHCP service, and configure the Commander.
  • Ensure that the new client has no configuration file.
  • Obtain the MAC address or ESN of each device to be configured by viewing the barcode label on the device.
  • Ensure that upgrade files or files to be downloaded have been uploaded to the working directory of the file server.

Procedure

Configure client replacement information.

  1. Run the system-view command to enter the system view.

  2. Run the easy-operation command to enter the Easy-Operation view.

  3. Run one of the following commands as required:

    • If the new client only needs to restore the configuration of the faulty client, run the client client-id replace { mac-address mac-address | esn esn } command to map the client-id to the MAC address or ESN of the new client.

    • If the new client needs to be upgraded or download other files, run the client client-id replace { { mac-address mac-address | esn esn } | system-software file-name [ version ] | patch file-name | web-file file-name | license file-name | { custom-file file-name } &<1-3> }* command to specify replacement information. The preceding configurations can be completed using the command once or multiple times. You must specify the faulty client ID and the MAC address or ESN of the new client in the command.

Configure an activation policy for downloaded files.

  1. Run the system-view command to enter the system view.

  2. Run the easy-operation command to enter the Easy-Operation view.

  3. Run the activate-file { reload | { in time | delay delay-time } }* command to configure an activation policy for downloaded files.

Replace the faulty device.

Remove the faulty device and connect the new device to the network.

Verifying the Configuration

  • Run the display easy-operation client replace [ verbose ] or display easy-operation client client-id replace command to check client replacement information on the Commander.
Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178413

Views: 68090

Downloads: 109

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next