No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S9300, S9300E, and S9300X V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Login Failure Through Telnet

Login Failure Through Telnet

Fault Description

The Telnet server fails to be logged in through Telnet.

Procedure

  1. Check whether the number of login users reaches the upper limit.

    Log in to the device through the console port and run the display users command to check whether all VTY user interfaces are in use. By default, the maximum number of VTY user interfaces is 5. You can run the display user-interface maximum-vty command to check the maximum number of login users allowed by the device.

    If the number of login users reaches the upper limit, run the user-interface maximum-vty 15 command to increase the maximum number of login users to 15.

  2. Check whether an ACL is configured in the VTY user interface view (Telnet IPv4 is used as an example).

    Run the user-interface vty command on the Telnet server to enter the user interface view and then run the display this command to check whether an ACL is configured in the VTY user interface view. If so, record the ACL number.

    Run the display acl acl-number command on the Telnet server to check whether the IP address of the Telnet client is denied in the ACL. If so, run the undo rule rule-id command in the ACL view to delete the deny rule and then run the corresponding command to modify the ACL and permit the IP address of the client.

  3. Check whether the access protocol is correctly configured in the VTY user interface view.

    Run the user-interface vty command on the Telnet server to enter the user interface view and then run the display this command to check whether protocol inbound is set to telnet or all. By default, the system supports the SSH protocol. If not, run the protocol inbound { telnet | all } command to allow Telnet users to connect to the device.

  4. Check whether an authentication mode is set for login users in the user interface view.

    • If password authentication is configured using the authentication-mode password command, you must enter the password upon login.

    • If AAA authentication is configured using the authentication-mode aaa command, you must run the local-user command to create a local AAA user.

Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178413

Views: 71532

Downloads: 110

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next