No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S9300, S9300E, and S9300X V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Deploying Unconfigured Devices Using the Commander

Verifying the Configuration of Deploying Unconfigured Devices Using the Commander

Procedure

  • Run the display ip pool { interface interface-pool-name | name ip-pool-name } used command to check the IP addresses that the DHCP server have assigned to clients.
  • Run the display easy-operation configuration command to check the configuration on the Commander.
  • Run the display easy-operation client [ client-id | mac-address mac-address | esn esn | verbose ] command to check the client on the Commander.
  • Run the display easy-operation group [ build-in [ device-type ] | custom [ groupname ] ] command to check group configuration on the Commander.
  • Run the display easy-operation download-status [ client client-id | verbose ] command to check file download status on a client.
  • (With network topology collection enabled) Run the display ndp command to check the NDP configuration.
  • (With network topology collection enabled) Run the display ndp interface { interface-type interface-number1 [ to interface-type interface-number2 ] }&<1-10> command to check neighbor information discovered through NDP on a specified interface.
  • (With network topology collection enabled) Run the display ntdp command to check the global NTDP configuration.
  • (With network topology collection enabled) Run the display ntdp device-list [ verbose ] command to check device information collected using NTDP.
  • (With network topology collection enabled) Run the display easy-operation topology command to check network topology information collected by the Commander.
Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178413

Views: 71977

Downloads: 110

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next