No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S9300, S9300E, and S9300X V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Batch Upgrade

Batch Upgrade

On a network supporting EasyDeploy shown in Figure 2-8, the clients need to be upgraded. This section describes how to perform a batch upgrade.

Figure 2-8  Networking for a batch upgrade
  1. The network administrator decides which devices are to be upgraded, prepares upgrade files, and makes an upgrade policy.
  2. The network administrator saves the upgrade files to the file server.
  3. The network administrator specifies the file server IP address, user name, password, and upgrade file information on the Commander.
  4. The Commander issues an upgrade instruction to the clients according to the upgrade policy, and the clients start the upgrade process.

Figure 2-9 shows the interaction between network devices during a batch upgrade.

Figure 2-9  Interaction between the network devices

The batch upgrade process goes through three stages:

  1. Obtain file information.

    The clients obtain file information from the Commander.

  2. Download files.

    The clients download the required files from the file server according to the obtained information.

    A client downloads files in the following sequence:

    1. System software
    2. Patch file
    3. License file
    4. Web page file
    5. Configuration file
    6. User-defined file
  3. Activate files.

    The client activates the downloaded files according to the configured file activation policy.

    If the client is a CSS, the downloaded files are copied from the master switch to slave switches when the file activation time is reached. After the file copy is complete, the client activates the files and then starts to operate normally.

During the batch upgrade process, if an error occurs (for example, the file server information is incorrect or a specified file does not exist), the clients stop the batch upgrade process and restore to the original running status. The downloaded files are retained on the clients. After a client fails to download a file, it tries again 1 minute later. If the download still fails after five retries, the client stops the upgrade process.

Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178413

Views: 68255

Downloads: 109

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next