No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Static Route Selection Based on Iteration Depth

(Optional) Configuring Static Route Selection Based on Iteration Depth

Context

Route iteration refers to the process of finding the directly-connected outbound interface based on the next hop of a route. Iteration depth refers to the number of times the system searches for the directly-connected outbound interface based on the next hop of a route.

When there are multiple static routes with the same prefix but different iteration depths, the system selects the static route with the smallest iteration depth as the active route. A smaller iteration depth indicates a more stable route. The system then delivers the active route to the FIB table after static route selection, based on the iteration depth configuration. The other static routes then become inactive.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip route-static selection-rule relay-depth

    Static route selection based on iteration depth is configured.

    By default, static routes are not selected based on iteration depth.

Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 199103

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next