No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling an Interface from Sending Update Packets

Disabling an Interface from Sending Update Packets

Context

Routing loops can be avoided by disabling interfaces from sending Update packets.

There are two ways to prevent interfaces from sending Update packets:
  • Suppress an interface in the RIP process view.
  • Disable an interface from sending RIP packets in the interface view.

The configuration in the RIP process view has a higher priority than the configuration in the interface view.

Procedure

  • Configuration in a RIP process view
    1. Run system-view

      The system view is displayed.

    2. Run rip [ process-id ]

      The RIP view is displayed.

    3. Run one of the following commands depending on the site requirements:

      Run silent-interface all

      All interfaces are disabled from sending Update packets.

      Run silent-interface interface-type interface-number

      An interface is disabled from sending Update packets,

      You can set an interface to silent so that it only receives Update packets to update its routing table. The silent-interface command takes precedence over the undo rip output command in the interface view.

      By default, an interface can receive and send Update packets.

  • Configuration in the interface view
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run undo rip output

      The interface is disabled from sending RIP Update packets.

      By running this command, you can determine whether to send RIP Update packets on an interface. The silent-interface command takes precedence over the undo rip output command. By default, an interface is allowed to send RIP Update packets.

Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 209155

Downloads: 47

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next