No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BFD for BGP

BFD for BGP

BGP periodically sends messages to peers to detect the status of the peers. It takes more than 1 second for this detection mechanism to detect a fault. When data is transmitted at gigabit rates, long-time fault detection will cause packet loss. This cannot meet high reliability requirements of networks. Bidirectional Forwarding Detection (BFD) provides the millisecond-level fault detection for BGP to improve network reliability.

Figure 9-11  Networking diagram of BFD for BGP

As shown in Figure 9-11, RouterA belongs to AS 100 and RouterB belongs to AS 200. RouterA and RouterB are directly connected and establish the EBGP peer relationship. Association between BGP and BFD is configured on RouterA and RouterB. When a fault occurs on the link between RouterA and RouterB, BFD can rapidly detect that the BFD session changes from Up to Down and notify this fault to RouterA and RouterB. RouterA and RouterB process the neighbor Down event and select routes again using BGP.

Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 196359

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next