Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPF Attribute Configuration
Prerequisites
The configurations for OSPF attributes on the NBMA network and P2MP network are complete.
Procedure
- Run either of the following commands to check LSDB information.
display ospf [ process-id ] lsdb [ brief ]
display ospf [ process-id ] lsdb [ { router | network | summary | asbr | ase | nssa | opaque-link | opaque-area | opaque-as } [ link-state-id ] ] [ originate-router [ advertising-router-id ] | self-originate ] [ age { min-value min-age-value | max-value max-age-value } * ]
- Run the display ospf [ process-id ] peer [ [ interface-type interface-number ] neighbor-id | brief | last-nbr-down ] command to view neighbor information.
- Run the display ospf [ process-id ] nexthop command to check next hop information.
- Run either of the following commands to check routing table information.
display ospf [ process-id ] routing [ ip-address [ mask | mask-length ] ] [ interface interface-type interface-number ] [ nexthop nexthop-address ]
display ospf [ process-id ] routing router-id [ router-id ]
- Run the display ospf [ process-id ] interface [ all | interface-type interface-number ] [ verbose ] command to check interface information.
Previous
