No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting an OSPF Packet Retransmission Limit

Setting an OSPF Packet Retransmission Limit


After an OSPF switch sends DD, LSU, or LSR packets but does not receive any LSAck packet within a specified time, the switch retransmits the packet. If the number of packet retransmissions reaches a specified limit, the switch tears down the adjacency relationship with its neighbor.


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run retransmission-limit [ max-number ]

    An OSPF packet retransmission limit is set.

    By default, the OSPF packet retransmission limit is not set. If an OSPF packet retransmission limit is set, the default max-number is 30.

Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 208699

Downloads: 47

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next