No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MP-BGP

Configuring MP-BGP

Pre-configuration Tasks

Before configuring MP-BGP, Starting a BGP Process.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    BGP is started, the local AS number is specified, and the BGP view is displayed.

  3. Enter the corresponding address family view based on network type to configure BGP devices on networks.
    • Run ipv4-family unicast

      The BGP-IPv4 unicast address family view is displayed.

    • Run ipv4-family vpnv4

      The BGP-VPNv4 address family view is displayed.

    • Run ipv4-family vpn-instance vpn-instance-name

      The BGP-VPN instance IPv4 address family view is displayed.

    • Run ipv4-family multicast

      The BGP-IPv4 multicast address family view is displayed.

    • Run ipv6-family unicast

      The BGP-IPv6 unicast address family view is displayed.

    • Run ipv6-family vpnv6

      The BGP-VPNv6 address family view is displayed.

    • Run ipv6-family vpn-instance vpn-instance-name

      The BGP-VPN instance IPv6 address family view is displayed.

    NOTE:
    • Different extended BGP functions must be configured in their respective address family views, while common BGP functions are configured in the BGP view.

    • The Switch supports the following MBGP features: basic BGP functions, BGP security (MD5 authentication and keychain authentication), simplifying IBGP network connections (route reflector and confederation), BGP route selection and load balancing, controlling the receiving and advertisement of BGP routes, adjusting the BGP network convergence speed, BGP reliability, BGP route summarization, and advertising default routs to peers.

    • Some BGP4+ functions can be configured in the BGP view, and some BGP4+ functions need to be configured in the IPv6 unicast address family view. For example, the following BGP4+ functions need to be configured in the IPv6 unicast address family view: load balancing, manual route summarization, route dampening, community, and route reflector.

Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 197898

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next