No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Displaying and Maintaining an IP Routing Table

Displaying and Maintaining an IP Routing Table

Context

You can view IP routing table information to locate routing faults. The following describes the commands used to display and maintain IP routing table information.

display commands can be used in all views, and reset commands can only be used in the user view.

If the switch imports a large number of routes, system performance may be affected when services are being processed because the routes consume a lot of system resources. To improve system security and reliability, configure a limit on the number of public route prefixes. When the number of public route prefixes exceeds the limit, an alarm is generated, prompting you to check validity of public route prefixes.

Procedure

  • Run the display ip routing-table command to check brief information about the active routes in the IPv4 routing table.
  • Run the display ip routing-table verbose command to check detailed information about the IPv4 routing table.
  • Run the display ip routing-table ip-address [ mask | mask-length ] [ longer-match ] [ verbose ] command to check detailed information about the routes with the specified destination address in the IPv4 routing table.
  • Run the display ip routing-table ip-address1 { mask1 | mask-length1 } ip-address2 { mask2 | mask-length2 } [ verbose ] command to check detailed information about the routes within the specified destination address range in the IPv4 routing table.
  • Run the display ip routing-table acl { acl-number | acl-name } [ verbose ] command to check detailed information about the routes that match the specified basic ACL in the IPv4 routing table.
  • Run the display ip routing-table ip-prefix ip-prefix-name [ verbose ] command to check detailed information about the routes that match the specified IP prefix list in the IPv4 routing table.
  • Run the display ip routing-table protocol protocol [ inactive | verbose ] command to check detailed information about the routes discovered by the specified routing protocol in the IPv4 routing table.
  • Run the display ip routing-table statistics command to check route statistics in the IPv4 routing table.
  • Run the display ipv6 routing-table command to check brief information about the active routes in the IPv6 routing table.
  • Run the display ipv6 routing-table verbose command to check detailed information about the IPv6 routing table.
  • Run the display ipv6 routing-table protocol [ inactive | verbose ] command to check detailed information about the routes discovered by the specified routing protocol in the IPv6 routing table.
  • Run the display ipv6 routing-table statistics command to check route statistics in the IPv6 routing table.
  • Run the reset ip routing-table statistics protocol { all | protocol } command to clear route statistics in the IPv4 routing table.
  • Run the reset ipv6 routing-table statistics protocol { all | protocol } command to clear route statistics in the IPv6 routing table.
Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 209015

Downloads: 47

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next