No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of BGP

Overview of BGP


The Border Gateway Protocol (BGP) is a path vector protocol that allows devices between Autonomous Systems (ASs) to communicate and selects optimal routes. BGP-1 (defined in RFC 1105), BGP-2 (defined in RFC 1163), and BGP-3 (defined in RFC 1267) are three earlier versions of BGP. BGP-4 (defined in RFC 1771) has been used since 1994. Since 2006, unicast IPv4 networks have been using BGP-4 defined in RFC 4271, and other networks (such as IPv6 networks) have been using Multiprotocol BGP (MP-BGP) defined in RFC 4760.

MP-BGP is an extension of BGP-4 and applies to different networks; however, the original message exchange and routing mechanisms of BGP-4 are not changed. MP-BGP applications on IPv6 unicast and IPv4 multicast networks are called BGP4+ and Multicast BGP (MBGP) respectively.


A network is divided into different ASs to facilitate network management. In 1982, the Exterior Gateway Protocol (EGP) was used to dynamically exchange routing information between ASs. However, EGP advertises only reachable routes and does not select optimal routes or prevent routing loops. Therefore, EGP cannot meet network management requirements.

BGP was designed to replace EGP and has the following capabilities:
  • Selects optimal routes.
  • Prevents routing loops.
  • Transmits routing information efficiently.
  • Maintains a large number of routes.

Although BGP is used to transmit routing information between ASs, it is not the best choice in some scenarios. For example, on the egress connecting a data center to the Internet, static routes instead of BGP are used for communication with external networks to prevent a huge number of Internet routes from affecting the data center internal network.


BGP ensures high network security, flexibility, stability, reliability, and efficiency:
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 207478

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next