No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing BGP Statistics

Clearing BGP Statistics

Context

BGP statistics cannot be restored after being cleared. Exercise caution when you clear BGP statistics.

Procedure

  • To clear route flapping statistics, run the reset bgp flap-info [ regexp as-path-regexp | as-path-filter as-path-filter-number | ipv4-address [ mask | mask-length ] ] command in the user view.
  • To clear route flapping statistics on a specified peer, run the reset bgp ipv4-address flap-info command in the user view.
  • To clear route dampening statistics and release suppressed routes, run the reset bgp dampening [ ipv4-address [ mask | mask-length ] ] command in the user view.
  • To clear MBGP route dampening statistics, run the reset bgp multicast dampening [ ip-address [ mask | mask-length ] ] command in the user view.
  • To clear MBGP route flapping statistics, run the reset bgp multicast flap-info [ ip-address [ mask | mask-length ] | as-path-filter { as-path-list-number | as-path-list-name } | regexp regexp ] command in the user view.
Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 208947

Downloads: 47

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next