No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an OSPFv3 Stub Area

Configuring an OSPFv3 Stub Area

Context

Perform the following operations on each switch that runs OSPFv3 in the area that will be configured as a stub area:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run area area-id

    The OSPFv3 area view is displayed.

  4. Run stub [ no-summary ]

    The area is configured as a stub area.

    The parameter no-summary takes effect only when the stub command is configured on the ABR. If this parameter is configured, the ABR only sends the summary-LSA of a default route to the stub area. It does not generate other summary-LSAs, such as AS-external-LSAs or Summary-LSAs. This area is called a totally stub area.

  5. (Optional) Run default-cost cost

    The cost of the default route sent to the stub area is set.

    By default, this cost is 1.

    Step 5 is performed only on the ABR. It is not necessary to perform this step on other switches in the stub area.

Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 205855

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next