No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RIPng

Enabling RIPng


Enabling RIPng is the prerequisite for all RIPng configurations. If you run RIPng commands in the interface view before enabling RIPng, the configurations take effect only after RIPng is enabled.


  1. Run system-view

    The system view is displayed.

  2. Run ripng [ process-id ] [ vpn-instance vpn-instance-name ]

    A RIPng process is created, RIPng is enabled, and the RIPng view is displayed.

    If a VPN instance is specified, the RIPng process belongs to this VPN instance. If no VPN instance is specified, the RIPng process belongs to a public network instance.

  3. (Optional) Run description text

    A description is configured for the RIP process.

Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 207682

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next