No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S9300, S9300E, and S9300X V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPFv3-BGP Synchronization

OSPFv3-BGP Synchronization

When a router is restarted or a new router is deployed on a network, network traffic may be lost during Border Gateway Protocol (BGP) convergence. This is because IGP convergence is faster than BGP convergence. OSPFv3-BGP synchronization can solve this problem.

When a router on a BGP network recovers from a fault, BGP convergence is performed again. Packets may be lost during the convergence.

Figure 6-5 shows traffic traversing a BGP network, passing through Router C from RouterA to RouterD.

Figure 6-5  Traffic traversing a BGP network

If a fault occurs on RouterC, traffic is redirected to RouterB after rerouting. Packets are lost when RouterC is restored to normal operating status.

This is because OSPFv3 convergence is already complete when RouterC recovers, and RouterC becomes the next hop on the route from RouterA to RouterD. However, at this point, BGP convergence on RouterC is not complete, so RouterC does not yet know the route to RouterD.

For this reason, when packets destined for RouterD are transmitted from RouterA to RouterC, they are discarded by RouterC because it has no route to RouterD. This is shown in Figure 6-6.

Figure 6-6  Packet loss upon device restart without OSPFv3-BGP synchronization

Process of OSPFv3-BGP synchronization

When a router enabled with OSPFv3-BGP synchronization restarts, it advertises a message in the local OSPFv3 area instructing other routers not to use it as a transit router.

At the same time, the router sets the cost value in its LSAs to 65535, the largest value. This ensures that it is not used by other routers as a transit router. The BGP route, however, can still reach the router.

Translation
Download
Updated: 2019-10-22

Document ID: EDOC1000178418

Views: 196247

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next