No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VRRP Group and Binding the VRRP Group to an mVRRP Group

Configuring a VRRP Group and Binding the VRRP Group to an mVRRP Group

Context

You can bind VRRP groups to an mVRRP group so that mVRRP determines the status of the bound VRRP groups.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface where a VRRP group is configured is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run vrrp vrid virtual-router-id virtual-ip virtual-address

    A VRRP group is created, and a virtual IP address is assigned to the VRRP group.

    By default, no VRRP group is created.

    Because the mVRRP group determines the status of its member VRRP groups, you do not need to set priorities for the member VRRP groups.

  5. Run vrrp vrid virtual-router-id1 track admin-vrrp interface interface-type interface-number vrid virtual-router-id2 unflowdown

    The VRRP group is bound to an mVRRP group. A VRRP group can be bound to only one mVRRP group.

    By default, no VRRP group is bound to an mVRRP group.

    After the binding is complete, the state machine of the bound VRRP group depends on the status of the mVRRP group. That is, the bound VRRP group inherits the status of the mVRRP group, deletes its VRRP Advertisement packet timeout timer, and stops sending or receiving VRRP Advertisement packets. A VRRP group can be bound to only one mVRRP group.

    NOTE:

    After a VRRP group is bound to an mVRRP group, VRRP Advertisement packets are not sent periodically. MAC addresses are updated based on ARP Reply packets for gratuitous ARP or from a gateway.

Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178423

Views: 88381

Downloads: 23

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next