No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between VRRP and a Card

Configuring Association Between VRRP and a Card

Context

If uplink outbound interfaces of a VRRP group are located on the same card, the card reset may cause a failure to forward user traffic because there is no outbound interface. In this situation, a VRRP active/standby switchover must be performed. The link monitored by BFD is normal and the BFD session does not go Down, so the millisecond-level switching performance cannot be ensured. After a BFD session is associated with a card and the card is set, the BFD session immediately goes Down, triggering the VRRP active/standby switchover. The switching performance is therefore improved.

In VRRP load balancing scenarios, if the switch is the master of VRRP group 1 and backup of VRRP group 2. When the BFD session becomes Down, the backup devices of VRRP groups 1 and 2 become master devices. The switch that switches from master to slave sends VRRP Advertisement packets and gratuitous ARP packets, affecting packet forwarding on the Layer switch at the access layer. The traffic from users to the network is forwarded to the new master device of a VRRP group, but the card of the new master device cannot forward traffic. Consequently, user packets are discarded.

After VRRP is associated with a card and the card is reset, the switch is suppressed from sending VRRP Advertisement packets and gratuitous ARP packets, preventing incorrect VRRP active/standby switchover.

NOTE:

The S9306 and S9312 support this command only when the MPU is equipped with the LE0MFSUA.

The S9306E and S9312E support this command only when the MPU is LH2D2SRUDC00/LE2D2SRUDC01.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vrrp track slot slot-id [ interval second-time ]

    VRRP is associated with a card.

    By default, VRRP is not associated with a card.

Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178423

Views: 88133

Downloads: 23

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next