No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S9300, S9300E, and S9300X V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Multicast MAC Ping

Configuring Multicast MAC Ping

Context

The destination MAC address of multicast MAC ping is a multicast MAC address. Multicast MAC ping provides two functions, that is, acknowledging faults and discovering RMEPs.
  • Acknowledging faults: Multicast MAC ping provides the fault acknowledgement function similar to that provided by 802.1ag MAC ping. In a multicast MAC ping test, test packets are sent to test whether the path from the local device to the destination device is reachable. Multicast MAC ping can acknowledge the faults of links between multiple MEPs once.

  • Discovering RMEPs: All RMEPs in the MA can be discovered.

    For example, there are three MEPs in an MA: MEP1, MEP2, and MEP3. After multicast MAC ping is configured on MEP1, MEP1 sends multicast LBMs. After MEP2 and MEP3 receive the LBM, they reply with an LBR. The LBR carries the MAC address of MEP2 or MEP3, MEP ID, and delay. Before configuring the remote-mep command on MEP1, you can configure multicast MAC ping to detect all RMEPs in an MA.

Implementation of multicast MAC ping depends on the maintenance domain (MD), maintenance association (MA), and maintenance association end point (MEP). Therefore, multicast MAC ping can be performed only on a network with MDs, MAs, and MEPs configured.

Perform the following steps on the edge device in an MA.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run cfm md md-name

    The MD view is displayed.

  3. Run ma ma-name

    The MA view is displayed.

  4. Run ping mac multicast mep mep-id [ -c count | -p priority-value | -t timeout ] *

    Multicast MAC ping is configured.

Translation
Download
Updated: 2019-04-17

Document ID: EDOC1000178423

Views: 88106

Downloads: 23

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next