No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Disk Encryption User Guide

OceanStor V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, 6800F V5, 18500 V5, 18500F V5, 18800 V5, and 18800F V5. It introduces how to install and configure key management servers connected to the storage systems that use self-encrypting disks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Powering On a Key Management Server

Powering On a Key Management Server

After connecting network cables of the key management servers, connect power cables and power on the key management servers.

Prerequisites

  • You have installed and connected network cables of the key management servers.
  • You have prepared the power cables.
  • You need to power on both of the two key management servers.

Procedure

  1. Wear ESD gloves and ESD wrist straps.
  2. Unpack power cables and adapter cables.
  3. Insert one end of the power cable to the power socket on the rear of the key management server, and the other end to the external power supply.
  4. If the external power supply is not turned on, turn it on.

    NOTE:

    The key management servers have no power switches. After their power cables are connected and the external power supplies are turned on, key management servers will automatically power on. The LCD on the key management server will flash slowly for approximately one minute and display the initialization information. The startup of a key management server takes several minutes. After the startup is complete, the LCD displays a message indicating that the server is ready.

  5. Repeat 3 and 4 to power on the other key management server.
Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181504

Views: 22947

Downloads: 181

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next