No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a 4 U Disk Enclosure (Applicable to 5000 and 6000 Series)

Installing a 4 U Disk Enclosure (Applicable to 5000 and 6000 Series)

Install a disk enclosure by sliding it into the cabinet, securing it, and checking the installation.

Prerequisites

  • The installation environment meets requirements.
  • Before installing a disk enclosure into a cabinet, ensure that the guide rails are installed properly.

The required installation tools and materials are as follows:

  • M6 screws
  • Phillips screwdriver (M3 to M6)

Precautions

Arrange for at least three persons to carry and install an enclosure to avoid personal injury or device damage.

  • If you remove disks to facilitate the movement and installation of the device, record the mapping between each disk and its slot in advance. That helps insert each disk back to its correct slot after the movement and installation.
  • Storage devices must be installed on adjustable guide rails. Stacking devices may damage devices.

Procedure

  1. Slide the disk enclosure into the cabinet and use M6 screws to secure it to the cabinet, as shown in Figure 5-80.

    Figure 5-80 Installing a disk enclosure into a cabinet

  2. Check that the disk enclosure is horizontally installed and tightly screwed in.
  3. If more than one disk enclosure is configured, repeat the preceding steps to install the other disk enclosures.
Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 94203

Downloads: 873

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next