No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Usage of Labels

Usage of Labels

This section describes how to use the labels, the contents on the labels, and the precautions for using the labels.

Contents on Labels

The contents on a label for a signal cable are different from the contents on a label for a power cable.

For a Signal Cable

The two sides of a label affixed to a signal cable indicate the location of the ports connected to both ends of the cable, as shown in Figure F-3.

  • Area 1 carries the location information about the cable end to which the label is to be affixed.
  • Area 2 (with the "TO:" mark) carries the location information about the other end of the cable.
  • Area 3 is folded between areas 1 and 2.
Figure F-3 Printing parts on a label for a signal cable

If the label is viewed from the cable leading-out area, it appears on the right side of the cable. The side with "TO:" that faces outward indicates the location of one end of the cable; the other side indicates the location of the other end.

For a Power Cable

A label for a power cable is affixed only to one side of the identification plate. The information (the part after the mark "TO:") on the label indicates the location of the peer end device, control cabinet, cable distribution box, or socket of the cable end to which the label is affixed.

Precautions for Using Labels

Pay attention to the following items when using the labels:

  • When you print or write information on the labels or attach the labels, ensure that the labels are clean.
  • Do not use ink-jet printers or ink pens to print or write on the labels because the label paper is made up of moisture-proof and waterproof material.
  • Affix labels neatly. The new label is of striped type. The appearance of the product is affected if the affixing position is incorrect.
  • Bundle the cable ties at the same height, and place all identification plates in the same direction.
  • The positions of "up", "down", "right", and "left" in this section (excluding the description of printer setting) are from the perspective of facing the labels.
Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 100697

Downloads: 948

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next