No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting IB Front-end Ports

Connecting IB Front-end Ports

Connect InfiniBand (IB) front-end ports on a controller enclosure to ports on an application server through Fourteen Data Rate (FDR) cables so that service channels are set up for data exchange between the storage device and the application server.

Prerequisites

The required installation tools and materials include FDR cables.

Context

A storage device can be connected to an application server in either of two ways:

Figure 6-62 IB ports on a 6 U controller enclosure directly connected to an application server

Figure 6-63 IB ports on a 6 U controller enclosure connected to an application server through IB switches

Procedure

  1. Connect one end of an FDR cable to an IB port.
  2. Set up a connection to an IB port on the application server.

    • Direct connection: Connect the other end of the FDR cable to an IB port on the application server.
    • Switch-based connection: Connect the other end of the FDR cable to a switch. Then connect the switch to the application server through an FDR cable.

  3. Repeat Step 1 to Step 2 to connect other IB ports to the application server.
  4. Lay out and bind the FDR cables.

    NOTE:

    For details about how to lay out and bind cables, see General Cable Routing Principles and Cable Routing and Bundling Basics.

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 92748

Downloads: 857

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next