No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Affixing Labels

Affixing Labels

The cable labels facilitate the cable connection and maintenance.

NOTE:

If the customers require label consistency in their equipment rooms, fill in and arrange the labels according to requirements.

This section describes how to attach a label for a signal cable and a power cable.

Affixing a Label to a Signal Cable

The label attaching position on a signal cable is 2 cm (0.788 in.) from the connector. In special cases, for example, to avoid bending the cable or affecting other cables, you can attach the label to a different position.

A label should be affixed to each end of a cable. When the cable is placed vertically, the label should point rightwards, and when the cable is placed horizontally, the label should point downwards. Figure F-5 shows how to properly attach a label to the signal cable.

Figure F-5 Properly affixing a label to a signal cable

Figure F-6 shows how to attach a label to a signal cable.

Figure F-6 Affixing a label to a signal cable

Affixing a Label to a Power Cable

Remove a label from the bottom of the label page, and then attach it to the concave part on either side of the identification plate of a cable tie. Ensure that the label directions are consistent in the equipment room. The cable tie should be fastened 2 cm (0.788 in.) from the connectors. In special cases, the labels can be affixed to other positions.

Cable ties should be fastened at both ends of a cable. After bundling the cables, the completed identification plate should be visible on the top of the cable in the horizontal cabling, or on the right side of the cable in the vertical cabling. Make sure that the label points outwards, as shown in Figure F-7.

Figure F-7 Appearance of a label affixed to a power cable
Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 94259

Downloads: 880

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next