No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Disk Module

Installing a Disk Module

After the high-density disk enclosure is installed into a cabinet, install the disk module.

Prerequisites

Ensure that the following condition is met before installing function modules:

Ensure that the following tools and materials are ready:

  • ESD wrist strap
  • ESD clothes
  • ESD gloves
  • Phillips screwdriver
  • M6 screw
  • Disk module
  • (Optional) Caution labels for the coffer disks (Required only when the caution labels have not been attached to the coffer disks.)

Procedure

  1. Loosen the two screws on the panel and pull out the system enclosure, as shown in Figure 5-94.

    Figure 5-94 Pulling out a node

  2. Open the system enclosure. Insert disks to coffer disk slots A0, A1, A2, and A3. Then insert disks from left to right (E to A) and from inside to outside (0 to 14). After disk modules are inserted into the vacant slots according to the arrow direction, buckle up the handle, as shown in Figure 5-96.

    Disk slots of high-density disk enclosures are numbered from 0 to 14 from left to right and from E to A from inward to outward, as shown in Figure 5-95.

    Figure 5-95 Disk slots number of high-density disk enclosures

    Figure 5-96 Installing a disk module

  3. (Optional) Attach the caution labels to the coffer disks. The caution labels of coffer disks of a high-density disk enclosure are attached on slots A0, A1, A2 and A3.

    NOTE:

    If the caution labels have been attached to the coffer disks, skip this step.

Follow-up Procedure

After the installation is complete, install filler panels to the vacant slots to ensure proper heat dissipation. For details about installation methods, see this section.

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 93779

Downloads: 871

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next