No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Installing a Cable Tray for a 3 U/6 U Controller Enclosure

(Optional) Installing a Cable Tray for a 3 U/6 U Controller Enclosure

Cable trays facilitate maintenance and cabling of interface modules. Each controller enclosure requires one cable tray.

Prerequisites

Ensure that the following tools and materials are ready:

  • M3 and M6 screws
  • Phillips screwdrivers (M3 and M6)
  • Marker
  • Protective gloves
  • Cable trays and trays
  • Square-hole positioning pins (for square-hole mounting bars)
  • Round-hole positioning pins (for round-hole mounting bars)

Context

  • If each controller is equipped with more than three interface modules, install a cable tray to facilitate maintenance and cabling of interface modules.
  • In a 3 U controller enclosure, install a cable tray under the controller enclosure (without intervals).
  • In a 6 U controller enclosure, install a cable tray 1 U (1 U = 44.45 mm) under the controller enclosure.

Procedure

  1. Determine the position for a cable tray. If the position is covered by a filler panel, mark the position.
  2. Extend the adjustable guide rail of the cable tray until positioning pins are inserted into the rear column.
  3. Use M6 screws to secure the adjustable guide rail, as shown in Figure 5-53.

    Figure 5-53 Installing a cable tray

  4. Use a Phillips screwdriver to fasten the M3 screws to secure the tray in place, as shown in Figure 5-54.

    Figure 5-54 Installing a tray

    NOTE:

    If the tray is too close to the controller enclosure, perform Step 5 and Step 6 to adjust the length of the cable tray for convenient cable trimming.

  5. (Optional) Loosen the M3 screws on the cable tray and adjust the position of the guide rail for convenient cable trimming, as shown in Figure 5-55.

    Figure 5-55 Adjusting the position of a cable tray

  6. (Optional) Fasten the M3 screws to secure the guide rail in place, as shown in Figure 5-56.

    Figure 5-56 Securing a guide rail in place

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 93636

Downloads: 871

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next