No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Installation Guide

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5300F V5, 5500 V5, 5500F V5, 5600 V5, 5600F V5, 5800 V5, 5800F V5, 6800 V5, and 6800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Management Network Ports to the Network

Connecting Management Network Ports to the Network

Connect management network ports on a controller enclosure to network ports on maintenance terminals through a LAN so that management channels are set up for maintenance terminals to manage and maintain the storage device.

Prerequisites

The required installation tools and materials include:

  • Network cables
  • Cable ties
  • Diagonal pliers

Context

  • Each controller is configured with a management network port and a maintenance network port. In normal cases, the management network port is used to configure and manage a storage device. The maintenance network port is designed for special maintenance in emergency.
  • The management network port and the maintenance terminal can correctly communicate with each other (the management network port and the maintenance terminal reside on the same network segment or reside on different network segments but are connected via a route).

Procedure

  1. Locate the network cables that are used to connect the management network ports (MGMT) on the controller enclosure. See Figure 6-64.

    Do not connect the management network port and maintenance network port to the same switch.

    Figure 6-64 Locating network cables

  2. Connect the network cables to the management network ports, as shown in Figure 6-65, Figure 6-66, and Figure 6-67.

    Figure 6-65 Connecting network cables to management network ports on a 2 U controller enclosure
    NOTE:

    Ensure that the management network ports of the two management modules are connected to the LAN.

    Figure 6-66 Connecting network cables to management network ports on a 3 U controller enclosure
    NOTE:

    Ensure that the management network ports of the two management modules are connected to the LAN.

    Figure 6-67 Connecting network cables to management network ports on a 6 U controller enclosure
    NOTE:
    • Ensure that the management network ports of the two management modules are connected to the LAN.
    • For a 6 U controller enclosure, connect only management network port 0 of the two management modules.

  3. Lay out and bind the network cables.

    NOTE:

    For details about how to lay out and bind cables, see General Cable Routing Principles and Cable Routing and Bundling Basics.

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181531

Views: 93718

Downloads: 871

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next