No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 2800 V5 V500R007

This document is applicable to OceanStor 2800 V5. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
xnet showrcvq

xnet showrcvq


The xnet showrcvq command is used to query information about messages in the current eth receiving queue.


xnet showrcvq { -c controller -p pid | -a } [ -f ]





controller Controller ID.

The value ranges from 0 to the number of controllers minus one.

pid Module ID.

The value ranges from 0 to 1023.

-a Collects statistics on messages corresponding to all PIDs.


-f Prints message information in the queue to the message log.



Diagnostic view

Usage Guidelines

  • This command is used by development engineers to locate faults.
  • When XNET messages fail to be sent or scheduled, you can run the command to view messages in the eth queue.
  • When running this command, ensure that parameter values are in the valid range.


  • Query information about messages in the current eth receiving queue.

    admin:/diagnose>xnet showrcvq -a
    Rcvq total msg num: 0.
  • Query information about messages of module "47" of controller "1" in the current eth receiving queue and print the information to the message log.

    admin:/diagnose>xnet showrcvq -c 1 -p 47 -f
    Rcvq nid(1) pid(47) msg num: 0.

System Response

The following table describes the parameter meanings.



Rcvq total msg num

Total number of messages in the eth receiving queue.

Rcvq nid

Node ID of the receiving queue.


Module ID.

Updated: 2020-01-17

Document ID: EDOC1000181575

Views: 724812

Downloads: 32

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next