Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change system work_mode
Function
The change system work_mode command is used to switch the system working mode. This command is used when you want to switch the system working mode.
Parameters
Parameter |
Description |
Value |
---|---|---|
environment_mode=? | Working environment mode that what you want to set. | The value can be "normal_mode" or "atrocious_mode", where:
|
Example
Switch the system working environment mode to "atrocious_mode".
developer:/>change system work_mode environment_mode=atrocious_mode WARNING: You are about to change the system working mode. This operation has the following risks: 1. If you are about to enable the atrocious mode, the self-protection function of the system will be disabled. The system continues to work in high-temperature and low-temperature environments, which may cause equipment damage. 2. If you are about to disable the atrocious mode, ensure that no level-2 high-temperature alarm exists. Otherwise, the controller that has the level-2 high temperature alarm will be powered off, and services may be interrupted. Suggestion: Before performing this operation, ensure that you really need to switch the working mode. Have you read warning message carefully?(y/n)y Are you sure you really want to perform the operation?(y/n)y Command executed successfully. developer:/>