change port fc_long_dis_perf
Function
Parameters
Parameter |
Description |
Value |
---|---|---|
fc_port_id=? | ID of a port. | To obtain the value, run "show port general". |
fc_long_dis_perf_enable=? | Remote transmission optimization function. | The value can be "yes" or "no", where:
|
Usage Guidelines
Before performing the operation, confirm that the FC port supports the remote transmission optimization function.
Example
Set the remote transmission optimization function on the FC port whose ID is "CTE0.A.H0". The ID and command output vary with the products.
developer:/>change port fc_long_dis_perf fc_port_id=CTE0.A.H0 fc_long_dis_perf_enable=yes WARNING: You are about to change the remote transmission optimization function on the FC port. This command can only be run on the FC port on the SmartIO interface module, SmartIO onboard port, and high-density card. After running this command, remote transmission performance will be optimized. Suggestion: Check whether the FC port is on the SmartIO interface module, SmartIO onboard port, and high-density card, and confirm that the operation purpose is to optimize remote transmission. Have you read danger alert message carefully?(y/n)y Are you sure you really want to perform the operation?(y/n)y Command executed successfully.