Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change rtt_switch general
Function
The change rtt_switch general command is used to manually configure the REQ time switch for an item.
Format
change rtt_switch general trace_id=? status=?
Parameters
Parameter |
Description |
Value |
|---|---|---|
trace_id=? |
The ID of item. |
The value ranges from 0 to 65536 or all. |
status=? |
The switch for an item. |
The value can be "open" or "close", where: 1."open": the switch for an item will be enabled. 2."close": the switch for an item will not be enabled. |
Views
Developer view
Usage Guidelines
- This command is effective for the local controller and does not affect the remote controller.
- System performance reduces if the REQ time switch for all items is enabled. Therefore, exercise caution when enabling the REQ time switch for all items.
Example
- To enable the REQ time switch for the item whose trace_id is 100, run the following command.
developer:/>change rtt_switch general trace_id=100 status=open Command executed successfully.
- To disable the REQ time switch for the item whose trace_id is 20, run the following command.
developer:/>change rtt_switch general trace_id=20 status=close Command executed successfully.
System Response
None
Previous
