showsysdirtydataflag.sh
Usage Guidelines
This command is a environment repair command. Use this command only when dirty data caused device power on to fail and you need to forcibly power on the device.
Example
Show the dirty data flags of logical engine nodes.
Storage: minisystem> showsysdirtydataflag.sh admin:/diagnose>sys showdirtydataflag Dirty data flag value: magic : 4951 frame sn : 2377993210796023840 serial num : 1 node bitmap : 3 admin:/diagnose>exit
System Response
The following table describes the parameter meanings.
Parameter |
Meaning |
---|---|
magic | Magic number, used to mark the validity of dirty data flags. |
frame sn | Serial number of a controller enclosure. |
serial num | Sequence number, used to indicate the updating sequence of dirty data. |
node bitmap | Node bit where the dirty data is valid. |